Fuel Filter Cross Reference

منتجات جديدة

أحدث الأخبار

Maintenance knowledge about fuel water separator

Maintenance knowledge about fuel water separator

One: start inspection and preparation 1: Before using the water separator equipment, the driver's consent should be obtained. 2: Check the line installation of the fuel water separator, whether the steering of the supporting pump is normal 3: Water is supplied to the fuel water separator, and the top air valve is opened to allow air to escape. 4: Check the oil and water separation in the marrow water inlet and outlet system without any leakage Two: precautions during operation 1: Adjust the drain valve opening degree and keep the pressure inside the separator to facilitate the elimination of the oil in the separator. 2: Observe whether the gauges such as pressure gauges and thermometers are normal. 3: Observe the working condition of the treated drainage water quality and oil concentration alarm 4: After the discharge is over, it should continue to be poured into clean water for 15 minutes to clean the separator. 5: Close the inlet and outlet after the pump is stopped, avoid the loss of clean water in the cylinder, reduce the oxidation and corrosion of the inner wall. 6: Each time the fuel water separator is used for discharge, it should be recorded in the oil beauty record book. Three: maintenance 1: Regularly clean the filter, open the bottom of the separator to vent, and remove the sediment deposited in the lower part, impurities 2: Clean the internal separation components of the separator in time, and avoid cleaning the inner wall and components of the separator with a cleaning agent. 3: When a fault occurs, the cause should be identified and the failed coalescing component should be replaced in time.

رأي :

أول 1 2 3 4 >> الاخير
[  ما مجموعه  4  صفحات]
عبر الانترنت


الدردشة الآن الرجاء الضغط هنا للاستفسار
إذا كان لديك أسئلة أو اقتراحات ، يرجى ترك لنا رسالة ، وسوف نقوم بالرد عليك في أقرب وقت ممكن!